Spiral Vibration Damper
The Spiral Vibration Damper is a motion control product used to dissipate aeolian vibration that may occur on cable spans. Using the recommended number of Spiral Vibration Dampers minimizes bending strain, protecting the cable from long-term fatigue due to aeolian vibration.
-
Helically-formed plastic rod provides an action/reaction motion that disrupts the natural vibration wave of the cable to dissipate aeolian vibration
-
Gripping section of the damper gently holds the cable
-
Effective in a broad range of frequencies
-
Easily installed by hand
-
Can be nested (subsetted), allowing easier installation for optimal protection against vibration
Application Procedures
SP2130-5 (Spiral Vibration Damper)
Catalog Pages
Spiral Vibration Damper - Distribution Catalog
Spiral Vibration Damper - Transmission Catalog
Spiral Vibration Damper - Fiber Networks and Communications Catalog
Spiral Vibration Damper - Tower & Antenna Catalog
Spiral Vibration Damper - FIBERLIGN® OPGW Hardware Catalog
Sales Materials
Spiral Vibration Damper - Sell Sheet
Reports & Manuals
Standard - For use on: Bare Conductors, Shield Wires and OPGW
Explanatory Notes: (1) Up to three SVD's can be subset together in one location where the cable diameter is 0.461" and below. (2) On cables with diameters above 0.461", only two SVD's should be subset for optimal damping performance.
Hi Mass - For use on: Bare Conductors, Shield Wires and OPGW
Explanatory Notes: (1) Up to three SVD's can be subset together in one location where the cable diameter is 0.461" and below. (2) On cables with diameters above 0.461", only two SVD's should be subset for optimal damping performance.