FIBERLIGN® ADSS Drop Cable Dead-End Classified as a formed wire design, The FIBERLIGN® ADSS Drop Cable Dead-End is able to secure the so.. Product #: FIBERLIGN ADSS Drop Cable Dead-end

FIBERLIGN® ADSS Drop Cable Dead-End


Classified as a formed wire design, The FIBERLIGN® ADSS Drop Cable Dead-End is able to secure the soft pliable surface of a drop cable without causing attenuation.  Unlike wedge type Dead-Ends, the formed wire Dead-End effectively transfers the axial load on the cable at the end of the Dead-End legs to a low uniform radial compression near the Dead-End loop. This transition of force is distributed over the length of the product thus allowing secure holding capability with minimized pressure on the cable or messenger.


  • Adapts to all ADSS Drop Designs
    • Round Profile
    • Flat Profile
  • Span Lengths up to 300’ (91.4 m)
    • Drop Applications (Structure to Premise)
  • Easy Installation - No Tools Required
  • Connect to Conventional Fittings
    • Direct Connection to 1.5” (38.1 mm) diameter fitting
    • Thimble used at J-hooks
  • Elevated temperature at 140o F (60o C) tensile test
    • Installation Load typically 100 lbs (45.36 kg)
  • Room temperature tensile test
    • Maximum Rated cable load 250 to 500 lbs (113.4 kg to 226.8 kg)

Fiberlign_ADSS_Drop_Cable_Dead-end.jpg