FIBERLIGN® ADSS Drop Cable Dead-end Classified as a formed wire design, The FIBERLIGN® ADSS Drop Cable Dead-end is able to secure the so.. Product #: FIBERLIGN ADSS Drop Cable Dead-end

FIBERLIGN® ADSS Drop Cable Dead-end


Classified as a formed wire design, The FIBERLIGN® ADSS Drop Cable Dead-end is able to secure the soft pliable surface of a drop cable without causing attenuation.  Unlike wedge type Dead-ends, the formed wire Dead-end effectively transfers the axial load on the cable at the end of the Dead-end legs to a low uniform radial compression near the dead end loop. This transition of force is distributed over the length of the product thus allowing secure holding capability with minimized pressure on the cable or messenger.

  • Adapts to all ADSS Drop Designs
    • Round Profile
    • Flat Profile
  • Span Lengths up to 300’ (91.4 m)
    • Drop Applications (Structure to Premise)
  • Easy Installation - No Tools Required
  • Connect to Conventional Fittings
    • Direct Connection to 1.5” (38.1 mm) diameter fitting
    • Thimble used at J-hooks
  • Elevated temperature at 140o F (60o C) tensile test
    • Installation Load typically 100 lbs (45.36 kg)
  • Room temperature tensile test
    • Maximum Rated cable load 250 to 500 lbs (113.4 kg to 226.8 kg)

Fiberlign ADSS Drop Cable Dead end